Angler's Fish-N-Mate Sr #143

This is the perfect beach cart.  It is large enough to carry your gear but also small enough to store easily.  This cart can be turned into a 4 wheel cart with very little effort. 

Care Instructions:

Air pressure must be maintained at all times

                Always wash your cart after saltwater use.(Car wash is ok).

                Make sure all spring pins and cotter pins are in place before taking your cart                    out

                Adjust the handle for proper height and be sure to keep the legs clear for                        travel

                Load your cart with the weight to the back of the axle, Balance your equipment

                Note: The rod holders were designed for carrying your rod only.   It is your                        option to use as a surf rod holder.

                If necessary, use silicon spray for lubricatio9n on axle

Parts List:

#1 Main frame with #8 rod holders attached
                #1 aluminum tee handle with foam grips

                #2 5X15 ½” pneumatic tires

                #1 5/8” axle 27” long

                #3 2/16” X 1 ½” Ss detent pins

                #4 5/8” ss Flat washers

                #2 U-bolt assemblies: (#2 ¼”x 2 ½” u bolts; #4 ¼” Hex nuts; #4 flat washers)

                #2 3/32” circle cotter pins

                #1 15/16”X11 ¾” aluminum leg(front)

                #1 15/16” X 0 ¾” aluminum leg(back)

                #1 frame with cutting board

                #5 6 3/8” screws for securing bait bucket

                #1 plastic bait bucket

                #8 plastic rod tube covers

Assembly Instructions:

                Remove cart from container

                Check all components with parts list

                Remove all parts from main frame

                Slide 5/8” axle thru U-bolts

Tighten U-bolts loosely

                Measure axle to get centered on frame

                Finish tightening U-bolts. Don’t over tighten

Put (1) 5/8” flat washer on each side of axle

                Slide a 5X15 ½” wheel on each side of axle

                Push a 3/32” circle cotter pin in hole on each side of axle

                Put 15/16” foam grip tee handle in 1 1/16” tubing & align to desired height

                 Put 15/16” aluminum front leg in the 1 1/16” tube & align to desired height

                Place cutting board with bait tray into any aluminum rod holder

Note: a back leg has been added to support the cart in the event you sit on the cart.   It will prevent it from tipping,   Remember to put the leg up and replace pin when moving the cart.

Outside Frame:

10" High

19" Wide

47 5/8" Long

Inside Frame:

9" High

17 1/4" Wide

41 3/4" Long

Shipping is included in the listed price.  Products shipped by Angler's Fish-N-Mate. Shipping and order fulfillment times may vary.